New to the quiver

So last year I started skiing seriously. I am not very good hence I retain the title climbwill while the other Will gets the ski prefix. Contributing to my lameness was that my old skis weighed next to nothing and were only 90mm at the tip: My 190 lb. carcass would just sink through all that powder we had last year. My new Voile Carbon Surfs, mounted with dynafit comfort bindings and driven by the Scarpa Matrix boot will hopefully change that (both the sinking carcass and the bad skiing that is).

The Voile skis have snowboard inserts. To mount the dynafits you have to obtain this grey plastic mounting plate. On the mounting plate there are three hole patterns on the for the rear binding piece for small medium and large boot sizes. The hole patterns are spaced 1 1/8 inches apart. The dynafits can adjust about 1 inch, leaving two 1/8 inch gaps between binding configurations on the ski. My boot landed just shy of this gap. The binding adjustment screw at its limit will just barely accommodates my boot. Either the guys at Voile checked to make sure that no major boots sizes' land in those gaps or they were just plain stupid. Mondo point sizes are not exactily equivalent to centimeter sizing: e.g. my 28.0 dynafit evolutions are slightly shorter than my 27.5 scarpa matricies. So it seems unlikely that they could ensure that all boots will fit their skis...

-w